found trouble code p0722 the transmission lead frame on the valve body will need to be replaced
PERFORM MULTIPOINT INSPECTION
REPLACED LEAD FRAME
REPLACED RIGHT OUTER ROD END
Place vehicle on alignment rack, attach equipment, measure caster, camber and toe. Compare to vehicle specifications. Set and adjust all approved alignment angles with allowable specifications.
TOM G. gave our service a 5 star review on 4/25/2025
CEL is on due to P0300 multiple cylinder misfire. Found that #6 was the lowest cylinder and had a slight tapping sound. Removed coil and plug to find the strap for the electrode has fallen off. Recommend starting with a set of plugs and coil boots for CEL. Also inform customer that the plugs could break off in the head and would need an additional hour per plug to replace. .
Brake light is on due to a improperly reading brake fluid level switch. Technician disconnected plug at fluid switch and found that there was no power or return signal at brake switch. Technician verified wiring between cluster and switch was good. Need to start with instrument cluster and programming.
Airbag light is on due to a fault in the PAD indicator circuit. Disconnected PAD indicator and found that the indicator was blown. Vehicle needs a new indicator
ROMAINE B. gave our service a 5 star review on 4/21/2025
During initial hour of diag technician found that car would not start due to a ground shorted Hi-Speed Can Bus. Technician Request additional time to trace wires and modules to find the cause for the short to ground. During wire chasing technician found that when disconnecting the bulk head connector for the Occupant Classification Module, that the ground short would go away. After removing Passenger seat technician found where several wires were rubbing the seat frame. Technician re-taped and re-secured the wires.
PERFORM MULTIPOINT INSPECTION
JOHN M. gave our service a 5 star review on 4/10/2025
HARD / NO START CUSTOMER STATED TRUCK WAS MISFIRING AND SKIPPING REALLY BAD PUT A COUPLE OF SPARK PLUGS IN AND MESSED WITH THE COILS NOW TRUCK WILL NOT START OR RUN CUSTOMER SAYS ACTS LIKE NO FUEL IN IT CHECK AND ADVISE
REPLACED SPARK PLUGS
Changed Motor Oil & Replaced Filter, Added Standard Motor Oil, Lube Chassis, Check all Fluid Levels
REPLACED IGNITION COIL
REPLACED AIR INTAKE HAD AFTERMARKET REPLACED WITH A FACTORY USED
RELEARN ECM
PERFORM MULTIPOINT INSPECTION
DARRELL C. gave our service a 5 star review on 1/23/2025